Diymore SD TF Card Board



The module (SD Card Adapter) is a SD card reader module, and the SPI interface via the file system driver, microcontroller system to complete the SD card read and write files.users can directly use the IDE comes with an SD card to complete thelibrary card initialization and read-write
Module features are as follows:
1 Support SD Card, SDHC card (high-speed card)
2 the level conversion circuit board that can interface level is 5V or 3.3V
3 power supply is 4.5V ~ 5.5V, 3.3V voltage regulator circuit board
4. Communication interface is a standard SPI interface
5. 4 M2 screw positioning holes for easy installation

Control Interface: A total of six pins (GND, VCC, MISO, MOSI, SCK, CS), GND toground, VCC is the power supply, MISO, MOSI, SCK is the SPI bus, CS is the chip select signal pin;

3.3V regulator circuit: LDO regulator output 3.3V as level converter chip, SDcard supply;

Level conversion circuit: card into the direction of signals into 3.3V, card toward the direction of the control interface MISO signal is alsoconverted to 3.3V, general AVR microcontroller system can read the signal;

SD card connector: yes since the bomb deck for easy card insertion and removal.

Positioning holes: 4 M2 screws positioning hole diameter of 2.2mm, the module is easy to install positioning, to achieve inter-module combination;